Jaguar Forum banner
1 - 11 of 11 Posts

Registered
Joined
5 Posts
Discussion Starter · #1 ·
I had my turbo fixed at a garage.
Today they called me up saying the new turbo is in, but the gear selector won't go down and the N letter is blinking.
I went there to check it myself.
When i press the start button the car runs. But the Knob stays up en de letter N starts blinking.
When i stop the engine. The gear selector still stays up and won't go down. Anyone else had this issue?

My car:
Jaguar XE 2.0D 163pk 2016

Thanks in advance
 

Registered
馃彺鬆仹鬆仮鬆伋鬆仯鬆伌鬆伩X260 R-Sport in Aurora Red
Joined
14,100 Posts
Has the emergency cord been pulled?
 
  • Helpful
Reactions: OBC John

Registered
馃彺鬆仹鬆仮鬆伋鬆仯鬆伌鬆伩X260 R-Sport in Aurora Red
Joined
14,100 Posts
Yes under the engine cover
 

Registered
馃彺鬆仹鬆仮鬆伋鬆仯鬆伌鬆伩X260 R-Sport in Aurora Red
Joined
14,100 Posts
I think they have pulled it, because they told me about it.
Ok you need to make sure it鈥榮 returned to it鈥榮 normal position.
 

Registered
Joined
25,010 Posts
Didn't I read a similar problem recently and it turned out the Bowden cable had kinked or something?
 

Registered
Battery powered superhero
Joined
5,743 Posts
Yes, the lever the cable operates via the handle on the side of the transmission was stiff and pushing the handle back wasn't fully pushing the lever. Get under the car and ensure the lever is being fully returned.
 
1 - 11 of 11 Posts
Top